You can also use different color paper strips which make a nice effect. Thus, you should use paper that is colored on both side. When you weave the 4 strips together, let the longer part be on top.Note: both the top and bottom side of the paper strip will be visible in the final star. For example, instead of folding 12″ into two 6″ parts, fold it so that one part is 5.25″ and the other side is 6.75″. Note: if you are using a strip of paper that is just barely long enough to complete a Moravian Star, then here is a useful tip: instead of folding the strips in half, offset them so one side is longer than the other. Rearrange the strips as in Part 5A above.Turn the model over to work on the other side.Rotate the model quarter turn, clockwise and repeat to form 3 more peaks. It will form a peak which is perpendicular to the points. If you lift the strip marked with a red X you will see that the strip of paper comes out from the points made in part 3 and 4.Tuck the strip of paper under the layer marked with a red X.Notice the line drawn on the strip of paper – this black line faces up all the time. When looping this strip of paper around, be sure not to flip it bottom-side up.Turn the same strip of paper around so it is pointing towards the left.Fold the top-right strip towards the right. ![]() If necessary, use tweezers to help grasp and pull the tapered ends of the paper. This next section is probably the most difficult part. Lastly, fold the strip marked with a red S to the right more firmly. Fold the strip marked with the red U to the left. Fold the strip marked with a red T down.Moved the strip marked with red S to the right to get it out of the way.Get ready to make the 4 peaks by re-arranging the strips of paper. The 8 points are outlined in white, some are hidden under layers.Flip the entire model bottom-side up and repeat the steps as in Part 3.When completing the steps on the last strip, you will need to lift a strip out of the way in order to weave the last strip.Rotate the paper quarter-turn, clockwise. Grasp the point firmly then weave the tail-end of the strip under the layer just below it.Fold this strip to the left so it lies ontop of itself.Fold the same strip down so it is adjacent to its original location.Fold the top-right strip behind and towards the right.Weave this last strip under the layer made in step A.Finally, fold the right-top strip to the left.Scoot the strips together to tighten the central square. For example, both ends of strip 1 should be in between strip 2.ĭ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |